Universal Custom File Bars for Metal or Wood Filing Cabinets or Desk Drawers

Wizard Custom File Bars and File Rails are for side to side filing
as well as front to back filing.

Wizard Custom File Bar System
#WFB40
40" Long x 1-1/2" high
Galvanized Steel
$10.34 ea.

Qty

See cutting Instructions Below

File Brackets to be Used With our Universal Bar

Wizard File Clip
Hanging Style
For Steel Cabinets only
#WFC41
$2.96 ea

Qty

New Wizard File Clip
Flush Mount
For Wood Cabinets only
# WFC42
$2.96 ea

Qty

Wizard File Bars or File Rails are available to be cut to your specifications.
Click for Cutting Orderform
Call for quantity pricing and cutting charges.

Note* Please use care in handling and preparation.
Rods may have some burring on the initial cuts.

Example
Drawer Size from wall to wall	Bar Size
27	26-7/8
30	29-7/8
33	32-7/8
39	38-7/8

Cutting Instructions

A- For Side-to-Side filing
Measure the inside distance from drawer wall to drawer wall. Then subtract 1/8" for the actual bar length. (see table as example)
Each clip takes up 1/16" (see above)
Cut the rod to the required dimension using a hack saw, chop saw or band saw.
If needed, use a file or piece of fine grit sandpaper to knock off any burr that may occur.

B-For Front-to-Back
First determine if there is a lip or edge that the clip can attach to. If so, the above instructions apply here also.
If not, than you must first create a side-to-side filing bar it now becomes the edge that the front-to-back bar attaches to.
*Don't forget to remove any sharp edges with a file.

When cutting your file bar or rail, Safety First.

	Welcome to Business Furniture Shop	Solution Provider...